Avaya Switch 5650 TD Basic configuration,hard reset,default admin user,LACP

Avaya Switch 5650 td

After connect console cable and power on switch.

Then in open serial port in putty and Press Ctrl + Y

Configure IP address and access web interface.

Default Admin user for Avaya switch is : RW  (for read and write)
For read only user : RO


For hard reset Avaya Switch 5650 td

Connect putty console cable and turn on switch and immediately press Ctrl+C wait for new menu popup

in menu choose 5 the option (Reinitialize conf)
erase all configuration and save and restart


Change switch name: 

#snmp-server name Switch01


To create new VLAN

#vlan create 100 name VOICE type port

#show vlan

vlan members remove 1 2,49,50

#vlan members add 100 2,49,50

(config)#interface vlan 100
(config)#ip address 10.10.10.0 255.0.0.0
(config)#exit
(config)#ip routing
(config)#vlan ports 2,49,50 tagging tagall
(config)#show run module vlan

(config)#interface fastEthernet 49,50

(config-if)#lacp key 10

(config-if)#lacp mode active

(config-if)#lacp timeout-time short

(config-if)#lacp aggregation enable

(config-if)#exit

(config)#show run module lacp

! Embedded ASCII Configuration Generator Script
! Model = Ethernet Routing Switch 5650TD
! Software version = v6.2.0.008
!
! Displaying only parameters different to default
!================================================
enable
configure terminal
!
! *** LACP ***
!
interface fastEthernet ALL
lacp key port 49-50 10
lacp timeout-time port 49-50 short
lacp aggregation port 49-50 enable
exit

(config)#show lacp port 49,50

                                  Admin Oper         Trunk Partner
Port Priority Lacp    A/I Timeout Key   Key   AggrId Id    Port    Status
---- -------- ------- --- ------- ----- ----- ------ ----- ------- ------
49   32768    Off     A   Short   10    0     0                    Down
50   32768    Off     A   Short   10    0     0                    Down

For Shutdown 

#shutdown minutes-to-wait 1